REMOVAL
The ASD relay is located in the engine compartment within the Power Distribution Center (PDC). Refer to label on PDC cover for relay location.
- Remove PDC cover.
- Remove relay from PDC.
- Check condition of relay terminals and PDC connector terminals for damage or corrosion. Repair if necessary before installing relay.
- Check for pin height (pin height should be the same for all terminals within the PDC connector). Repair if necessary before installing relay.
INSTALLATION
The ASD relay is located in the Power Distribution Center (PDC). Refer to label on PDC cover for relay location.
- Install relay to PDC.
- Install cover to PDC.
The ignition key must be in the key cylinder for cylinder removal. The key cylinder must be removed first before installing ignition switch.
Scheme 8
Scheme 9
Scheme 10
Scheme 11
- Before installing ignition switch, rotate the slot in the switch to the ON position. 1 - Ignition Switch 2 - Ignition Switch Mounting Screws
- Connect the electrical connector to rear of the ignition switch. Make sure that locking tabs are fully seated into wiring connector.
- Position switch (1) to column and install the mounting screw (2). Tighten screw to 3 N.m (26 in. lbs.). 1 - IGNITION SWITCH 2 - TILT LEVER MECHANISM
- Install the tilt lever bracket (2) mounting screws. Tighten screws to 4.5 N.m (40 in. lbs.). 1 - Ignition Switch Mounting Screws 2 - Non-Tilt Mounting Bracket Screws
- If the column is non-tilt install the bracket (2). Tighten screws to 4.5 N.m (40 in. lbs.). (Scheme 11) 1 - KEY CYLINDER 2 - GEAR SHIFT LEVER 3 - MOUNTING HOLES 4 - STEERING COLUMN 5 - IGNITION SWITCH
- Position the wire retainer into the tilt lever bracket.
- Reconnect the lower clockspring connectors.
- Install the key cylinder (1)
- Install steering column upper and lower shrouds.
- Enable the airbag system. «(Refer to ELECTRICAL/RESTRAINTS/DRIVER AIRBAG - INSTALLATION)»(ref-247645-S09956156402007020100000).