Home ReviewsRefund
Home/Dodge/Caliber/Dodge Caliber I (2006-2009)/Repair manual/Differential & Driveline/ELECTRONICALLY CONTROLLED CLUTCH
Contents Wiring diagrams Section: Differential & Driveline All sections

ELECTRONICALLY CONTROLLED CLUTCH Dodge Caliber I

Differential & Driveline ~127 words

ELECTRONICALLY CONTROLLED CLUTCH

  1. Raise vehicle on a hoist.
  2. Remove the rear propeller shaft. See «REMOVAL»(ref-284872-S37282389302008051600000) .
  3. Remove the exhaust system up to the catalytic converter. Refer to «REMOVAL»(ref-284874-S10307318942008051600000) .
  4. Disconnect ECC breather hose.
  5. Remove the routing bracket bolt.
  6. Unplug the electrical connector (3).
  7. Remove the four ECC mounting bolts (1).
  8. Slide ECC from rear axle and lower.
  9. Remove all old gasket material on the mating surfaces of the ECC and RDA. Remove wave washer.
  1. Slide ECC into rear axle.
  2. Install the four ECC mounting bolts and tighten to 68 N.m (50 ft. lbs.).
  3. Plug the electrical connector (3) in.
  4. Install the routing bracket bolt and tighten to 14 N.m (124 in. lbs.).
  5. Install the rear propeller shaft. See «INSTALLATION»(ref-284872-S33756759132008051600000) .
  6. Install the exhaust system.