Home ReviewsRefund
Home/Dodge/Cab & Chassis R3500 HD/Dodge Cab & Chassis R3500 HD (2008-2009)/Repair manual/5.7L Engine - Service Information/HYDROSTATIC LOCK
Contents Wiring diagrams Section: 5.7L Engine - Service Information All sections

HYDROSTATIC LOCK Dodge Cab & Chassis R3500 HD

5.7L Engine - Service Information ~218 words

HYDROSTATIC LOCK

CAUTIONDO NOT use the starter motor to rotate the crankshaft. Severe damage could occur.

When an engine is suspected of hydrostatic lock (regardless of what caused the problem), follow the steps below.

  1. Perform the Fuel Pressure Release Procedure. Refer to «STANDARD PROCEDURE»(ref-303863-S37168526502008103100000) .
  2. Disconnect the negative cable(s) from the battery.
  3. Inspect air cleaner, induction system, and intake manifold to ensure system is dry and clear of foreign material.
  4. Place a shop towel around the spark plugs to catch any fluid that may possibly be under pressure in the cylinder head. Remove the spark plugs.
  5. With all spark plugs removed, rotate the crankshaft using a breaker bar and socket.
  6. Identify the fluid in the cylinders (coolant, fuel, oil, etc.).
  7. Be sure all fluid has been removed from the cylinders.
  8. Repair engine or components as necessary to prevent this problem from occurring again.
  9. Squirt a small amount of engine oil into the cylinders to lubricate the walls. This will prevent damage on restart.
  10. Install new spark plugs. Tighten the spark plugs to 41 N.m (30 ft. lbs.).
  11. Drain engine oil. Remove and discard the oil filter.
  12. Install the drain plug. Tighten the plug to 34 N.m (25 ft. lbs.).
  13. Install a new oil filter.
  14. Fill engine crankcase with the specified amount and grade of oil.
  15. Connect the negative cable(s) to the battery.
  16. Start the engine and check for any leaks.