Manual sections
Wiring diagrams- Battery
- Body
- Bodywork
- Braking
- Comfort and convenience
- Confort
- Current generation
- Dashboard
- Electrical harnesses
- Engine
- Front anti -roll bar
- Front axle
- Front doors
- Front seats
- Front section
- Front springs
- Gearbox assembly
- General points
- General points about the vehicle
- Instrument panel
- Instruments and controls
- Lighting - signalling
- Mechanical
- Other
- Power unit
- Pre-heating
- Protections and doors
- Rear axle
- Rear door windows
- Rear doors
- Rear seats
- Rear section
- Rear shock absorbers
- Rear springs
- Roof bow
- Roof panel
- Side structure
- Starting
- Steering
- Suspension
- Transmission
- Washing and wiping
Repair manual
Power unit Citroen Nemo I
Step-by-step instructions on "Power unit" for Citroen Nemo I (2008–2015). Pick an article — removal, installation, adjustment and diagnostics with illustrations.
Articles in this section
- Identification - data: DV4TED engine (DV4TED)
- Tightening torques: engine assembly mountings - gearbox (DV4TED)
- Tightening torques: engine assembly suspension - gearbox (TU3AE5, TU3A)
- Tightening torques: TU3A engine (TU3A, TU3AE5)
- Tightening torques: engine assembly mountings - gearbox (1.3 HDI 75)
- Checking and adjusting values: DV4TD - DV4TED engine type (DV4TED)
- Checking and adjusting values: TU3 engine type (TU3AE5, TU3A)
- Checking and adjusting values: F13DTE engine type (1.3 HDI 75)
- Tightening torques: F 13 DTE5 engine type (1.3 HDI 75)
- Technical note: engine oil capacities
- Technical note: general engine information
- Technical note: ancillary drive belt
- Identification: DV4TD engine (DV4TED)
- Identification - data: injector carrier seals (DV4TED)
- Tightening torques: DV4TD - DV4TED engines (DV4TED)
- Identification: engine (TU3A)
- Tightening torques: tu engines (8 valves) (TU3A)
- Identification: tooling (engine reconditioning) (TU3A)
- Checks: pressure, engine end of compression (TU3A)
- Check: pressure, engine end of compression (DV4TED)
- Checking: pressure, engine end of compression (1.3 HDI 75)
- Checks: pressure, engine end of compression (TU3AE5)
- Removal - refitting: engine assembly - gearbox (TU3A, TU3AE5)
- Removing - refitting: engine - gearbox (DV4TED)
- Removing - refitting: engine/gearbox assembly (1.3 HDI 75)
- Removing - refitting: engine - gearbox (1.3 HDI 75)
- Dismantling: engine top F13 DTE 5 (1.3 HDI 75)
- Dismantling: under engine f 13 dte 5 (1.3 HDI 75)
- Refitting: under engine f 13 dte 5 (1.3 HDI 75)
- Refitting: engine top f 13 dte 5 (1.3 HDI 75)
- Dismantling: DV4TD engine (DV4TED)
- Refitting: DV4TD engine (DV4TED)
- Refitting: engine (cast iron cylinder block) (TU3A)
- Dismantling: engine (TU3A)
- Refitting: engine (aluminium block) (TU3A)
- Prohibited operations: HDI direct injection system (BOSCH) (1.3 HDI 75)
- Prohibited operations: hdi direct injection system BOSCH
- Prohibited operations: hdi direct injection system DENSO
- Prohibited operations: petrol direct injection system THP
- Prohibited operations: hdi direct injection system CONTINENTAL-SIEMENS
- Prohibited operations: HDI direct injection system BOSCH (DV4TED)
- Fitting: engine on stand (F 13 DTE5) (1.3 HDI 75)
- Fitting: engine on stand (DV4TED)
- Fitting: engine on stand (TU3A)
- Dismantling: engine (DV4TED)
- Stripping: engine (DV4TED)
- Refitting: engine (DV4TED)
- Re-assembling: engine (DV4TED)
- Removal / refitting: Coolant temperature sensor (1.3 HDI 75)
- Operating methods: DV4TD engine (hdi direct injection system BOSCH EDC16C3) (DV4TED)
- Presentation: injection system VALEO V34.1 (TU3E5 engine)
- Operating methods: TU3A engine - injection system (SAGEM J34P) (Summary) (TU3A)
- Presentation: F13DTE5 engine - direct injection system HDI MAGNETI MARELLI MJ8DF2
- Operating methods: Stop and Start system (engine F13DTE5) (1.3 HDI 75)
- Operating methods: hdi direct injection system "MAGNETI MARELLI MJ8DF2" (F13DTE5 engine) (1.3 HDI 75)
- Operating methods: injection system (engine TU3E5)
- General: HDI direct injection system (BOSCH EDC 16 C3) (DV4TED)
- Function: fuel supply (BOSCH EDC 16 C3) (DV4TED)
- Function: air supply (BOSCH EDC 16 C3) (DV4TED)
- Function: exhaust gas recycling (BOSCH EDC 16 C3) (DV4TED)
- Function: pre-postheating (BOSCH EDC 16 C3) (DV4TED)
- Function: BOSCH EDC 16 C3 direct diesel injection ECU (DV4TED)
- Function: engine cooling (BOSCH EDC 16 C3) (DV4TED)
- Function: air conditioning cooling requirement (BOSCH EDC 16 C3) (DV4TED)
- Maintenance: injection system BOSCH EDC 16 C3 (DV4TED)
- Identification - data: air supply circuit (DV4TED)
- Tightening torques: components of the fuel circuit (1.3 HDI 75)
- Location: engine speed sensor
- Function: ignition system (TU3A)
- Function: fuel vapour recycling (canister) (TU3A)
- Location: components of the pre-post heating system
- Location: components of the fuel circuit
- General - presentation: injection j34p (TU3A)
- General synopsis: injection system j34p (TU3A)
- Check: fuel high pressure supply circuit (BOSCH assembly) (1.3 HDI 75)
- Check: low pressure fuel supply circuit (TU3A)
- Function: air supply (TU3A)
- Function: fuel supply (TU3A)
- Check: low pressure fuel supply circuit (DV4TED)
- Maintenance: injection system J34P (TU3A)
- Check: low pressure fuel supply circuit (1.3 HDI 75)
- Function: injection (TU3A)
- Check: low pressure fuel supply circuit (TU3AE5)
- Check: high pressure fuel circuit (DV4TED)
- Function: engine cooling incorporated in the injection ECU (TU3A)
- Remove - refit: engine management ECU (TU3AE5, TU3A)
- Function: cooling requirement for the air conditioning (TU3A)
- Removing - refitting: engine speed sensor (TU3A, TU3AE5)
- Removing - refitting: engine ECU (DV4TED)
- Tightening torques: components of the fuel circuit (TU3AE5)
- Removing - refitting: inlet air temperature sensor (DV4TED)
- Removing - refitting: fuel temperature sensor (DV4TED)
- Removing - refitting: engine speed sensor (DV4TED)
- Location: components of the Volt control system
- Removing - refitting: camshaft position sensor (DV4TED)
- Removing - refitting: high pressure fuel sensor (DV4TED)
- Removal - refitting: petrol injector (TU3A)
- Remove - refit: knock sensor (TU3AE5, TU3A)
- Removing - refitting: diesel injector (DV4TED)
- Removing - refitting: fuel high pressure common injection rail (DV4TED)
- Removing - refitting: high pressure fuel pump (DV4TED)
- Removing - refitting: camshaft position sensor (1.3 HDI 75)
- Removing - refitting: inlet air pressure sensor (1.3 HDI 75)
- Removing - refitting: inlet air temperature sensors (1.3 HDI 75)
- Removing - refitting: high pressure fuel sensor (1.3 HDI 75)
- Removing - refitting: Fuel temperature sensor (1.3 HDI 75)
- Removing - refitting: engine speed sensor (1.3 HDI 75)
- Removing - refitting: fuel high pressure common injection rail (1.3 HDI 75)
- Removing - refitting: high pressure fuel pump (1.3 HDI 75)
- Removing - refitting: diesel injector (1.3 HDI 75)
- Removing - refitting: Engine management ECU (1.3 HDI 75)
- Removing - refitting: fuel flow regulation electrovalve (1.3 HDI 75)
- Removal - refitting: petrol injector (TU3AE5)
- Drain - refill: fuel tank
- Cleaning: unions on the fuel high pressure common injection rail (DV4TED)
- Cleaning: unions on the fuel high pressure common injection rail (HDI) (1.3 HDI 75)
- Modification: turbocharger lubrication pipe banjo bolt (DV4TED)
- Modification: high pressure fuel pump (DV4TED)
- Remove - refit: spark plugs (TU3A)
- Removing - refitting: sparking plugs (TU3AE5)
- Technical note: additives for particle filter
- Removing - refitting: exhaust gas temperature sensor (1.3 HDI 75)
- Operating methods: immobiliser (Summary)
- Description - function: inlet air temperature and pressure sensor
- Description - operation: particulate filter upstream gas temperature sensor
- Description - function: proportional oxygen sensor
- Description - function: cylinder reference sensor
- Description - function: pre-post heat box
- Description - function: engine speed sensor
- Description - function: coolant temperature sensor
- Description - operation: preheater plugs
- Description - function: engine oil pressure switch
- Description - function: fuel flow regulation valve
- Remove - refit: spark plugs (TU3AE5)
- Description - function: fixed geometry turbocharger
- Description - operation: high pressure fuel pump
- Description - function: temperature and water in diesel sensor
- Description - function: EGR exchanger by-pass all-or-nothing electrovalve
- Description - operation: air con fluid linear pressure sensor
- Function: cooling requirement for the air conditioning (BRAC)
- Description - function: inlet air temperature and pressure sensor — variant 2
- Description - operation: diesel injectors
- Description - function: Diesel high pressure sensor
- Function: air supply
- Description - function: particle filter differential pressure sensor
- Function: Fan regulation internal control (FRIC)
- Function: fuel supply system
- Description - operation: vacuum pump
- Description - function: fuel gauge pump
- Description - function: inlet air mixer unit with position repeat sensor
- Description - operation: oil pump
- Description - function: engine ECU (MAGNETI MARELLI MJ8DF2)
- Function: particulate filter regeneration
- Function: exhaust gas recycling (EGR)
- Description - function: electrically-controlled exhaust gas recycling module
- Flow chart: hdi direct injection system MAGNETI MARELLI MJ8DF2
- Function: cooling requirement for the air conditioning (BRAC) — variant 2
- Function: fuel supply
- Flow chart: injection system VALEO V34.2 (TU3E5 engine)
- Table: fault codes - TU3AE5 (valeo V34.2) engine (TU3AE5)
- Table: fault codes - 1.3 JTD (MAGNETI MARELLI 8DF2) engine (1.3 HDI 75)
- Table: fault codes - DV4TD (bosch EDC16C34) engine (Summary) (DV4TED)
- Table: fault codes - TU3AE5 (VALEO V34.P) engine (TU3AE5)
- Table: fault codes - 1.3 JTD (MAGNETI MARELLI 8DF3) engine (1.3 HDI 75)
- Help in diagnosis: diagnostic warning lamp lights - 1,3 JTD engine (1.3 HDI 75)
- Help in diagnosis: diagnostic warning lamp lights - engines TU1A-TU3A euro 5 (TU3AE5)
- Help in diagnosis: 1,3 JTD (MAGNETTI MARELLI 8DF3) engine (1.3 HDI 75)
- Presentation: engine tools DV6 and DV4 16 valve types (DV4TED)