WarningObserve the safety and cleanliness recommendations
WarningGloves and protective goggles must be worn for the following operations
Tooling
Presentation
- Glazing tools
- Glazing consumables
Removing
Remove (inner side)
- The windscreen pillar trims
- The interior mirror
- The rain sensor (according to equipment)
Remove (towards the outside)
- The wiper blades
- The scuttle grille (see the relevant operation)
- The lower windscreen aperture trims (see the relevant operation)
- The windscreen trim clip
- The lower windscreen clip
Protect the windscreen aperture surround; using adhesive tape (1)
Pass the cutting wire [1354-E] through the sealing adhesive; using tool [1354-C]
Cut out the seal adhesive bead on the windscreen aperture surround; using tools [1354-C], [1354-D] and [1354-E]
NoteFor the following operation 2 people are necessary
Remove the windscreen; using the double hinged suction cups [KIT1-VENT]
Cleaning - preparation
Preparing the windscreen
1er cases: reusing the glass
Fit the electric cutter [FEIN-400E] with blade N°146
Remove the sealing adhesive strip
Remove any dust using a clean cloth
NoteOnly apply the primer to the zones laid bare
2nd case: fitting of a new windscreen (2)
Degrease around the edge of the windscreen (2) using the degreaser provided in the bonding kit
From the edge of the seal of the windscreen (2), mark the bonding route on the printed area; using a lead pencil
- In the area "a" to 5 mm
- In the area "c" to 10 mm
Apply the glass primer provided in the bonding kit
Leave to dry for 10 minutes
NoteOnly apply the primer to the zones laid bare
Preparation of the aperture
1er cases: on residue sealant
Fit the electric cutter [FEIN-400E] with blade N°146
Remove the sealing adhesive strip
Remove any dust using a clean cloth
NoteOnly apply the primer to the zones laid bare
Leave to dry for 10 minutes
2nd case: new component
Degrease the flange using the degreaser provided in the bonding kit
Apply the panel primer provided in the bonding kit
Leave to dry for 10 minutes
Refitting
WarningIf a two-pack product is used: the time from fitting the windscreen (2) on the vehicle to starting to extrude the seal adhesive is 5 minutes
Equip the gun with the cartridge and the special nozzle
Apply a strip of sealing adhesive around the windscreen aperture
Offer up the windscreen to the aperture using suction pads [KIT1-VENT]
Check the fits and clearances of the windscreen (2)
Press gently around the edge of the windscreen (2)
Verify: the sealing of the windscreen (2)
Proceed in the reverse order to removal
Clean the windscreen (2) and its surround
Check the operation of the equipment