WarningObserve the safety and cleanliness recommendations
Tooling
Presentation
- Glazing tools
- Glazing consumables
Removing
Remove (from inside the vehicle)
- The windscreen pillar trims (see the relevant operation)
- The interior mirror
Remove the scuttle grill (see the relevant operation)
"c": stops
WarningGloves and protective goggles must be worn for the following operations
Protect
- The headlining
- The fascia
- The cover
- The front wings
Protect the periphery of the windscreen aperture with adhesive tape (at "a")
Using pliers [1354-C], insert the piano wire [1354-E] through the polyurethane seal adhesive
Secure the cutting wire on the handles [1354-D]
Pull the handles [1354-D] along, exerting a sawing movement
WarningThe piano wire must remain taut at all times
WarningDo not damage the vehicle's paintwork when detaching the windscreen aperture. when removing the windscreen aperture, insert a plastic sheet " b " between the piano wire [1354-E]and the dashboard to avoid scratching the safety pad covering
Remove the windscreen; using the double hinged suction cups [KIT1-VENT]
Remove the 2 stops " c "
Cleaning and preparation
On the windscreen glass
Remove the sealing adhesive strip; using tool [FEIN-400E] fitted with blade n°146 (on the windscreen)
Level off: the cushioning seals
NoteAlways replace: the cushioning seals
Degrease the windscreen using the A3 type degreasing agent
Leave to dry for 10 minutes
If a new windscreen is fitted
- Apply the A3 type glass primer
- Leave to dry for 10 minutes
On the vehicle
Remove the rough bead of adhesive sealant " d " using a scraper to guarantee optimum contact
Touch up with anti-corrosion product
Degrease the flange " e " using the "A3" type degreasing agent
Leave to dry for 10 minutes
Apply an A3 type metal primer
NoteOnly apply the primer to the zones laid bare
Position the new stops on the body as indicated above
Refitting
Cushioning seals
Glue: the cushioning seals
Windscreen
Cut back the nozzle to a triangular section
Apply the bead of A3 type adhesive sealant to the edge of the windscreen
WarningIf a two-pack product is used. the time specified for fitting the windscreen to the vehicle and the start of extrusion of the seal adhesive is 5 minutes
WarningCheck that the stops " c " are fixed to the body structure
Offer up the windscreen to the aperture; using the double hinged suction cups [KIT1-VENT]
Press gently all around the edge of the windscreen
Clean the windscreen and its surround
Refit the parts removed