Removal
Camshaft Position (CMP) sensor is located on front of timing case cover. Disconnect CMP sensor wiring harness connector. Loosen CMP sensor bolt and remove sensor. Removal force may be high due to "O" ring seal on sensor. DO NOT pull on sensor lead to remove sensor.
Installation
- If old sensor is being reused, remove old paper spacer from sensor face. Install a new paper spacer to sensor face before installing sensor. Install NEW "O" ring on sensor. If installing a new sensor, ensure paper spacer is attached to sensor face and "O" ring is positioned correctly.
- Apply oil to sensor "O" ring. Install CMP sensor by pushing down until paper spacer makes contact with cam timing gear. Hold sensor in position and tighten CMP sensor bolt to specification. See «TORQUE SPECIFICATIONS»(ref-24727-S30163839652001010500000) . Connect sensor wiring harness connector.