The ECM detects a high voltage signal on the TCC brake signal circuit for more than 2 seconds when the serial data message from the BCM indicates the brakes are released. The ECM sets the DTC when the condition has been detected 8 out of 10 times.
Contents
Wiring diagrams Section: Cruise Control Systems- Cruise Control System: Overview
- Cruise Control System: Diagnosis
- Cruise Control System: Other
- B3794 08
- B3794 61
- P0564
- P0567
- P0568
- P0572
- P0573
- Abbreviations
- Airbag
- Anti-Lock/traction Control
- Automatic HVAC System
- Automatic Trans
- Axle Shafts
- Basic Trouble Shooting
- Body Electrical
- Brakes
- Charging System
- Check Lists
- Collision/avoidance
- Communication Devices
- Cooling System (Mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Differentials & Drive Axles
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- Driveshaft & Universal Joints
- DTC Index
- Electrical
- Electrical Component Locations
- Electronic Steering
- Electronic Suspension
- Emission Applications
- Engine
- Engine Control Systems
- Engine Performance
- Entertainment Systems
- Exhaust
- Exterior Body Panels
- Exterior Lights
- Exterior/interior Trim
- Frames, Subframes & Crossmembers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Heated Glass/defoggers
- Horns
- Identification
- Ignition Switch/steering Lock
- Lubrication System
- Manual HVAC System
- Mechanical
- Mechanical - Hydraulic
- Memory Modules
- Metric Conversions
- Mirrors
- Mode 6
- Oem General Information
- Paint/coatings
- Parking Brake System
- Reset Procedures
- Restraints Control Systems
- Seats
- Specifications
- Steering
- Steering Column Switches
- Steering Linkage
- Sun Roof/t-Top/convertible Top
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Towing Systems
- Traction Control Disable
- Transfer Case
- Transmission
- Warning System
- Wheel & Tire System
- Wheel Alignment
- Wiper/washer Systems