ACTUATOR
| WARNING | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION section before disconnecting battery. |
Actuator is located on steering column. (Scheme 116) Move actuator rod to adjuster block side for leverage. (Scheme 117) Press on adjuster block to compress internal adjuster spring and engage adjuster teeth. Slide adjuster block as far away from solenoid as possible. Reposition actuator rod to solenoid side. Rod will be visible in hole in actuator block.
Scheme 116
Scheme 117
PARK LOCK CABLE
- Lift cable lock button. Move gearshift lever to Park. Snap cable connector into shifter base. Ensure ignition key is in RUN position.
- Snap cable housing into ignition switch inhibitor. Turn ignition key to LOCK position. Snap cable end onto park lock lever pin. Remove slack from cable connector. Snap cable connector lock button down.
