DRAINING FUEL FROM WATER/FUEL SEPARATOR (DIESEL)
| WARNING | Diesel fuel system may be contaminated with fungi or other microorganisms. Keep contaminated fuel away from open skin cuts or sores to prevent skin irritation or infection. |
| WARNING | DO NOT drain fuel/water separator when engine is running or hot. Allow engine to cool before draining. Verify that the WATER IN FUEL light on instrument panel is OFF. |
- Turn off engine and block drive wheels.
- Remove fuel filler cap(s) to release any pressure or vacuum in the vehicle fuel tank(s).
- Place a suitable container under the filter drain hose.
- Open the drain valve. (Scheme 2)
- Start engine and allow to idle for 1 to 2 minutes or until clear fuel is observed.
- Close the drain valve and stop the engine.
- Replace fuel filler cap(s).
- Dispose of drained mixture in a proper manner.
Scheme 2
Note. For more information regarding Diesel Idle Speed Adjustments refer to the ADJUSTMENTS - 6.5L DIESEL article in the ENGINE PERFORMANCE section.
AXLE FLUID
| CAUTION | Axle lubricant should be changed whenever the axle has been submerged in water. Water can enter through the axle vent hole and contaminate the lubricant. |
STARTING FLUID USE (TURBO DIESEL)
| WARNING | DO NOT USE starting fluids (ether) or flammable liquids to aid the starting of a Diesel engine. NEVER pour diesel fuel, flammable liquids or starting fluids into the air cleaner canister, air intake or turbocharger housing in an attempt to start the vehicle. A flash fire may result causing personal injury. |
