REMOVAL & INSTALLATION
Same procedure is used to remove and install locking differential as conventional differential. See appropriate DRIVE AXLE article in this section.
- On 9 1/2" ring gears, remove stop pin. On all models, use Governor Remover (J-26252) and remove governor bushing. Remove "C" clips which hold latching bracket in position on bracket shaft. Move bracket down shaft.
- Using same tool, remove latching bracket bushing. Remove latching bracket, shaft and spring from case. Remove governor assembly from case. Remove lock screw, pinion shaft, differential pinion gears and pinion thrust washers. Rotate one side gear and roll gears out of case.
- Remove thrust block, right side gear, right disc pack and side thrust washer. Remove left side gear, cam plate and disc pack as a unit. Remove thrust washer.