TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Axle Shaft (Hub) Nut | 284 (385) | |
| Ball Joint | ||
| To Control Arm Bolt/Nut | (1) | |
| To Steering Knuckle Nut | (2) 41 (55) | |
| Brake Caliper | ||
| Bracket Bolts | 85 (115) | |
| Mounting Bolts | 23 (31) | |
| Crossmember Bolts | ||
| Front | 44 (60) + 120 degrees | |
| Rear | 74 (100) + 180 degrees | |
| Hub & Bearing Assembly Bolts | 70 (95) | |
| Intermediate Shaft Lower Pinch Bolt | 15 (20) | |
| Lower Control Arm-To-Crossmember Bolts | ||
| Front | 85 (115) + 120 degrees | |
| Rear | 181 (245) + 180 degrees | |
| Stabilizer Bar | ||
| Insulator Bracket Bolts | 49 (66) | |
| Link-To-Lower Control Arm Nut | 13 (17) | |
| Strut Assembly | ||
| To Steering Knuckle Nuts | 133 (180) | |
| To Upper Body Mount Fasteners | 18 (25) | |
| Rod (Piston) Nut | 52 (70) | |
| Tie Rod | ||
| (Prevailing Torque) Ball Stud Nut | 15 (20) | |
| Jam (Adjuster) Nut | 55 (75) | |
| Transmission Mount Bolt | 89 (120) | |
| Wheel Lug Nut | 103 (140) | |
| (1) Tighten to specification indicated in service ball joint kit. (2) Tighten nut to specification, then tighten nut further to align cotter pin. DO NOT tighten nut more than 50 ft. lbs. (68 N.m) | ||
| (1) | Tighten to specification indicated in service ball joint kit. |
| (2) | Tighten nut to specification, then tighten nut further to align cotter pin. DO NOT tighten nut more than 50 ft. lbs. (68 N.m) |
TORQUE SPECIFICATIONS