Home/Chevrolet/Equinox/Chevrolet Equinox II (2009-2015)/Repair manual/Lighting System/Intermittent

Contents

Wiring diagrams Section: Lighting System

Fastener Tightening Specifications

Diagnostic Code Index

Diagnostic Instructions

Diagnostic Fault Information

Circuit/System Description

Conditions for Running the DTC

Conditions for Setting the DTC

Action Taken When the DTC Sets

Conditions for Clearing the DTC

Reference Information

Circuit/System Verification

Circuit/System Testing

Repair Instructions

Actions Taken When the DTC Sets

Diagnostic Aids

Symptoms - Lighting

Visual/Physical Inspection

Intermittent

Symptom List

Brake Pedal Position Sensor Calibration

Calibration Criteria

Calibration Procedure

Brake Pedal Position Sensor Replacement

Aiming Headlamps (Visual Aim)

Headlamp Aiming Procedure

Fog Lamp Aiming (Equinox)

Preparation Procedure

Aiming Procedure

Exterior Lamps

Low Beam Headlamps (Standard) RPO TT4

Adaptive Forward Lighting

Automatic Lamp Control

Flash to Pass (Standard) RPO TT4

Flash to Pass (up level) RPO TT2/TT6

Automatic Headlamp Leveling

Daytime Running Lamps (DRL) without HID RPO TT4

Daytime Running Lamps (DRL) with HID RPO TT2/TT6

Front Fog Lamps

Rear Fog Lamps

Park, Tail, License and Marker Lamps

Turn Signal Lamps

Repeater Lamps

Hazard Flasher Lamps

Stop Lamps

Backup Lamps

Battery Run Down Protection/Inadvertent Power

Interior Lamps

Courtesy/Illuminated Entry Lamps

Keyless Entry Interior Illumination

Interior Lamps Dimming

Inadvertent Power

All sections

Intermittent Chevrolet Equinox II

Lighting System

Intermittent

Thoroughly inspect the wiring and connectors. An incomplete inspection of the wiring and connectors may result in misdiagnosis causing part replacement with the reappearance of the malfunction. If an intermittent malfunction exists, refer to Testing for Intermittent Conditions and Poor Connections .