REMOVAL & INSTALLATION
Note. For removal and installation procedures of column mounted switches, see STEERING COLUMN SWITCHES article.
- Disconnect negative battery cable. Place wheels in straight-ahead position. On models with standard steering wheel, remove horn button retaining screws from rear of steering wheel. Disconnect wiring from horn button and remove.
- On models with sport steering wheel (round horn button), remove horn button by pulling button upward. If necessary, remove horn internal components. Place components in order of removal. To install, reverse removal procedure.
Note. For removal and installation procedures of column mounted switches, see STEERING COLUMN SWITCHES article.
- Remove horn button. On vehicles with sport steering wheel, remove bushing, receiver and flex plate from steering wheel. On all models, remove steering wheel retaining nut.
- Place reference mark on steering wheel and shaft for reassembly reference. Using steering wheel puller, remove steering wheel. To install, reverse removal procedure. Align marks made during removal. Tighten steering wheel nut to 25 ft. lbs. (34 N.m).
- Replace negative battery cable, reset clock and radio stations if applicable. Check horn, and turn signal for correct operation.
See also:
• STEERING COLUMN SWITCHES