Object Detection System - Park Assist System: Removal & Installation Chevrolet Captiva I facelift

Removal Procedure

1. Remove rear bumper fascia. Refer to «Rear Bumper Fascia Replacement»(ref-490208-S08496419212012072700000) .
2. Disconnect electrical from the rear object sensor.
3. Lift the locking tabs on the housing and remove the rear object sensor.

Installation Procedure

1. Paint the rear object sensor. Refer to «Basecoat/Clearcoat Paint Systems»(ref-490230-S07016323892012072700000) .
2. Ensure the paint does not exceed 6 mils. Use a paint thickness gauge suitable for non-ferrous metals. Refer to «Paint Gauges»(ref-490230-S29631371242012072700000) .
3. Insert the sensor into the housing.
4. Connect the electrical connector to the rear object sensor.
5. Install the rear bumper fascia. Refer to «Rear Bumper Fascia Replacement»(ref-490208-S08496419212012072700000) .

Rear Object Sensor Housing Replacement

1. Remove the rear fascia. Refer to «Rear Bumper Fascia Replacement»(ref-490208-S08496419212012072700000) .
2. Disconnect the sensor harness.
3. Remove the sensor from the sensor housing.
4. Paint the new sensor. Refer to «Basecoat/Clearcoat Paint Systems»(ref-490230-S07016323892012072700000) .
5. Inspect the paint thickness to ensure it does not exceed 6 mm using a paint thickness gauge suitable for non-ferrous metals. Refer to «Paint Gauges»(ref-490230-S29631371242012072700000)
6. Sand/grind sonic weld plastic residue from the fascia.
7. Apply structural adhesive epoxy, Lord Fusor™ 127EZ or equivalent, to fascia at mating surface.
8. Using the alignment tabs, install the sensor housing to the fascia.
9. Allow adhesive to cure according to manufacturer's directions.
10. Install the sensor to the sensor housing.
11. Connect the electrical harness.
12. Install the rear fascia. Refer to «Rear Bumper Fascia Replacement»(ref-490208-S08496419212012072700000) .

Scheme 2

Rearview Camera Replacement