Starter Removal & Installation Chevrolet Camaro II

2.0L 4-CYL.

1. Disconnect negative battery cable at battery. Remove solenoid wires and battery cable from starter. Remove rear starter support bracket.
2. If equipped, remove A/C compressor support rod. Remove 2 starter-to-engine bolts. Remove starter from vehicle.

4.3L V6 DIESEL FRONT WHEEL DRIVE

1. Disconnect negative battery cable at battery. Install engine support fixture (J-22825-45, J-22825-1, J-22825-48). Raise vehicle on hoist.
2. Remove left and center engine mount stud nuts. Remove 2 front cradle mount bolts. Lower cradle. Remove 4 flywheel cover bolts. Remove flywheel cover (2 pieces).
3. Remove starter shield nut at starter. Remove flex shield. Disconnect wires from starter. Remove 2 starter bolts. Remove starter.

ALL OTHER ENGINES

1. Disconnect negative battery cable at battery. Raise vehicle on hoist. Remove starter braces and shields.
2. Remove 2 starter-to-engine bolts. Allow starter to drop down. Remove solenoid wires and battery cable from starter. Remove starter.