Programming and Setup - All Systems: Adjustments Buick Enclave I facelift

Liftgate Calibration

If any portion of the power liftgate assembly is replaced, repaired or disassembled, perform the following liftgate calibration procedure

1. Ensure that the rotary switch on the overhead console is set to Enable.
2. On the scan tool, select Body, select Liftgate Module, select Module Setup
3. Perform the scan tool LGM Open/Close Test

See also:
• Radio Scan Tool Information
• Digital Radio Receiver Scan Tool Information
• Body Control Module Scan Tool Information
• Electronic Brake Control Module Scan Tool Information
• K20 Engine Control Module: Scan Tool Information (LLT)
• Engine Controls Schematics
• Driver Seat and Passenger Seat Heater Control Module Scan Tool Information
• Heating, Ventilation and Air Conditioning Control Module Scan Tool Information
• Airbag Vehicle Rollover Sensor Scan Tool Information
• Inflatable Restraint Sensing and Diagnostic Module Scan Tool Information
• Chassis Control Module Scan Tool Information
• Liftgate Close Actuator Motor Control Module Scan Tool Information
• Seat Memory Control Module Scan Tool Information
• Front and Rear Parking Assist Control Module Scan Tool Information
• Rear Differential Clutch Control Module Scan Tool Information
• Theft Deterrent Module Scan Tool Information
• Transmission Control Module Scan Tool Information
• Automatic Transmission Controls Schematics
• Communication Interface Module Scan Tool Information
• Remote Control Door Lock Receiver Scan Tool Information
• Inflatable Restraint Passenger Presence System Scan Tool Information
• Instrument Cluster Scan Tool Information
• Door Lock Control Module Scan Tool Information (Driver Door Lock/Window Switch)