Home/BMW/Z3/BMW Z3 E36 рестайлинг (2000-2002)/Repair manual/Oem General Information/Operating Fluids - Maintenance & General Information: Other
Contents Section: Oem General Information All sections

Operating Fluids - Maintenance & General Information: Other BMW Z3 E36 рестайлинг

2.0 Corrosion Protection For Vehicle In Long-term Storage

Location - inside of a building whenever possible or covered parking lot (especially convertibles).

Replace engine oil and filter after engine reaches operating temperature. Run engine several minutes after replacing oil.

Engine oil must be replaced every 12 months. Factory engine oil (in new cars) can remain in the engine up to 12 months.

Check/correct electrolyte level in battery cells.

Disconnect battery ground lead to avoid discharging battery through current draw of electrical equipment. Or, switch off battery main disconnect switch (if equipped).

Recharge battery according to repair instructions.

Inspect undercoating for damage and repair as necessary.

Inspect wax coating in engine compartment, on engine, underbody and axles. Repair as necessary.

Operate air conditioner monthly for 10 minutes in order to lubricate the seals and the expansion valve. Note: The air conditioner will only work at temperatures above 37°F/3°C.

Pre-Delivery Cars

Replace brake fluid if car has been parked outdoors longer than six (6) months.

Fill the vehicle fuel tank with fresh fuel in order to prevent condensation inside the tank (applies only to metal fuel tanks).

Check, and if needed, correct the coolant level and concentration of long-term antifreeze and corrosion inhibitor.

Apply brakes to dry the brake discs of any moisture and spray them with a corrosion inhibitor. Spray the complete brake assemblies after parking the car at its final storage location.

Do not apply the parking brake. Brake linings could seize when the parking brake is applied for an extended period of time. Rather, engage first gear (manual transmissions) or " park" position (automatic transmissions) to hold vehicle stationary.

Increase inflation pressure on all road tires to 50 psi.

Thoroughly clean the entire car, including underside, engine and engine compartment.

Exterior Finish

Repair any damage to the paint finish. Wash entire vehicle exterior with BMW Car Wash Shampoo (Part No. 82 14 9 400 129) or equivalent. Polish painted and chrome finishes with Car Polish Cream - 3M Part No. 6055 (former BMW Part No. 82 14 9 400 131) or equivalent.

Polishing the vehicle with abrasive cleaners and/or cleaner waxes may have a detrimental effect on the appearance of the paint. Waxing of Paint Sealer treated vehicles may still be done, but only if non-abrasive cleaners or non-abrasive cleaner-waxes are used.

Wax painted and chrome finishes with BMW Car Wax (Part No. 83 12 9 408 527) or equivalent.

Wax painted and chrome plated parts if storage period is 12 months or longer. Dewax and rewax cars every six (6) months if stored outside.

Check convertible top for damage.

3.0 Conversion Table

LitersUS GallonsUS PintsLitersUS GallonsUS Pints
0.50.1321.0558.02.11216.904
1.00.2642.1139.02.37619.017
2.00.5384.22610.02.64021.130
3.00.7926.33911.02.90423.243
4.01.0568.45212.03.16825.356
5.01.32010.56513.03.43227.469
6.01.58412.67814.03.69629.582
7.01.84814.79115.03.96031.695

CONVERSION

Conversion Factors

Liters in US Gallons x 0.264

US Gallons in Liters x 3.785

Liters in US Pints x 2.113

US Pints in Liters x 0.473

4.0 Alternate Universal Lubricants And Workshop Supplies

BMW P/NDescription/Application3M P/NWurth P/NLoctite P/N
81 22 9 400 208 (1)Lubricant/Contact Cleaner Spray (2)89360/124379
81 22 9 400 229 (1)Hand Cleaner (3)89390025108
81 22 9 400 720 (1)Molybdenum Disulfide (MOS 2 ) Spray (4)887624378
81 22 9 407 138 (1)Stain Remover (5)89024
81 22 9 407 174 (1)Bearing Grease (6)893530
81 22 9 407 301 (1)Loctite 574 (7)89357424018
81 22 9 407 388 (1)Adhesive Remover (8)8984
81 22 9 407 394 (1)Loctite 380 (9)8155893 410338050
81 22 9 407 524 (1)Contact Cement (10)1357HP
81 22 9 407 629 (1)High-Adhesion Lubricant (11)887820029
81 22 9 407 711 (1)Universal Lube Spray (12)887889310620029
(1) These items are no longer available through BMW NA Parts Department. (2) Stops electrical and mechanical faults due to water, moisture, rust, dirt and friction. Colorless, neutral, free of grease and silicone, suitable for all applications. Examples: Stops moisture on distributor, generator, ignition coil, starter, spark plugs, coils, relays, contacts, etc. Prevents metal parts from corroding. Stops rubber and plastic parts from aging prematurely. Applications: from -50°C to +150°C. (3) Removes stubborn stains and grit without attacking skin. Contains special skin protectant. Does not clog pipes. (4) Loosens rust, eliminates squeaking and similar noises, prevent rust seizure. Displaces water on ignition components to allow quick starting. Insulates electrical systems against moisture and stops corrosion. (5) Removes tar, oil and grease stains from seat covers, leather upholstery and painted plastic components. (6) A water repellent high-pressure grease for lubricating flywheel gear rings, starter motor pinions, etc., and also as an acid-proof grease for battery terminal posts. (7) Anaerobic, silicone sealant for aluminum flange surfaces. Provides instant sealing when flanges are assembled. (8) Removes all residual or excess adhesive, sealing and coating compounds, wax, grease or oil films from painted and plastic surfaces, i.e. before installing front or rear spoilers and decor strips. (9) Black cyanacrylate adhesive for joining metals, rubber, PVC. (10) Powerful adhesive for leather and leatherette, rubber moldings, seats, rubber mats, noise-absorbent materials, etc. Has good heat resistance and does not attack paint. See S.I. Bulletins B 54 02 95 and B 54 01 93 (3754). (11) Long-life high-adhesion lubricant for clutch and brake linkages, spring struts, stabilizers, idler levers and pivots. (12) Colorless lubricant with high lubricant content. Eliminates squeaks and grating noises from spring seat bases. Lubricates door stops and locks, seat adjustment mechanism, etc. Resistant to temperatures between -50°C and 120°C.
(1)These items are no longer available through BMW NA Parts Department.
(2)Stops electrical and mechanical faults due to water, moisture, rust, dirt and friction. Colorless, neutral, free of grease and silicone, suitable for all applications. Examples: Stops moisture on distributor, generator, ignition coil, starter, spark plugs, coils, relays, contacts, etc. Prevents metal parts from corroding. Stops rubber and plastic parts from aging prematurely. Applications: from -50°C to +150°C.
(3)Removes stubborn stains and grit without attacking skin. Contains special skin protectant. Does not clog pipes.
(4)Loosens rust, eliminates squeaking and similar noises, prevent rust seizure. Displaces water on ignition components to allow quick starting. Insulates electrical systems against moisture and stops corrosion.
(5)Removes tar, oil and grease stains from seat covers, leather upholstery and painted plastic components.
(6)A water repellent high-pressure grease for lubricating flywheel gear rings, starter motor pinions, etc., and also as an acid-proof grease for battery terminal posts.
(7)Anaerobic, silicone sealant for aluminum flange surfaces. Provides instant sealing when flanges are assembled.
(8)Removes all residual or excess adhesive, sealing and coating compounds, wax, grease or oil films from painted and plastic surfaces, i.e. before installing front or rear spoilers and decor strips.
(9)Black cyanacrylate adhesive for joining metals, rubber, PVC.
(10)Powerful adhesive for leather and leatherette, rubber moldings, seats, rubber mats, noise-absorbent materials, etc. Has good heat resistance and does not attack paint. See S.I. Bulletins B 54 02 95 and B 54 01 93 (3754).
(11)Long-life high-adhesion lubricant for clutch and brake linkages, spring struts, stabilizers, idler levers and pivots.
(12)Colorless lubricant with high lubricant content. Eliminates squeaks and grating noises from spring seat bases. Lubricates door stops and locks, seat adjustment mechanism, etc. Resistant to temperatures between -50°C and 120°C.

ALTERNATE UNIVERSAL LUBRICANTS AND WORKSHOP SUPPLIES