Automatic Coding Procedure
When a control module is replaced that does not store the ZCS code, the replacement module is coded automatically using the ZCS code stored in the Kombi, EWS or LSZ.
From Progman establish a connection to the interface connected to the vehicle and access CIP.
To perform the procedure from CIP the Model series must be selected (3 series, 7 series ...).
Then select the body (E32, E36 ...).
Scheme 409
Select "Codierung ZCS/FA".
Then advance screen to the right two times to enter the vehicle series selection screen.
Scheme 410
The version ID page is displayed.
Make sure it is the most up-to-date version of the software for the encoding procedure.
Press the right arrow.
Scheme 411
Select vehicle series (i.e "E36 Series").
Scheme 412
Select "Recoding"
Then advance screen to the right.
Scheme 413
Displays control modules that are ZCS codable.
Example
Select "ZVN II/GM (ZKE IV)".
Scheme 414
Confirm module selection.
Scheme 415
If a replacement module is to be installed install it now.
Scheme 416
Select yes to begin coding or recoding the selected module.
Scheme 417
Coding/recoding process of selected module is complete, follow the instructions given.
