Preparation
Conform with the following when starting the engine with a jump starting cable.
- Ensure that the jump starting cable wires are of appropriate cross-section size.
- Only use fuse-protected jump starting cables.
- Check whether the current-supplying battery has 12 V voltage.
- If the engine is started from the battery of another vehicle, ensure that there is no contact between the bodies of both vehicles.
| IMPORTANT | Never touch electrically live ignition system components: high voltage - danger of injury! |
If the battery in the vehicle supplying power is weak, start the engine of this vehicle and let it run at idling speed.
Do not allow any battery acid to come into contact with the eyes, the skin or clothing. Therefore wear protective clothing, gloves and goggles.
Do not tilt the battery, acid may emerge from the vent opening.
If acid is splashed into the eyes, rinse them immediately for several minutes with clear water. You must then consult a doctor without delay.
If acid is splashed onto the skin or clothing, neutralize it immediately with a soapy solution and rinse with lots of water.
Seek medical attention immediately if battery acid is accidentally swallowed.
Strictly no flames, sparks, naked light or smoking!
A highly explosive mixture of electrolytic gas is created when batteries are charged. The rooms where charging is carried out must therefore always be well ventilated.
Avoid the formation of sparks when handling cables, wiring and electrical devices.
Turn the ignition lock to the 0 position before disconnecting or connecting the battery.
Do not place tools or any similar object on the battery (danger of short-circuiting and explosion!).