Coding Code Procedure
With the original module still installed in the vehicle, select the Coding/Programming function which can be accessed through Progman with CIP 15.0 or higher using the DISplus/GT1 or SSS.
Scheme 70
Scheme 71
- From Progman establish a connection to the interface connected to the vehicle and access CIP To perform the procedure from CIP the Model series must be selected (3 series, 7 series ...) Then select the body (E32, E36 ...)
- Select "Codierung ZCS/FA" (Advance screen to the right two times to enter the selection screen.)
- Select: Specific model series
- Select: "Recoding" or "Coding Code"
- Select: "Replacement part"
- Select: Specific system/module to be coded
- Turn off ignition and remove the old module, install new module and turn ignition on.
- Advance the screen and enter "0" plus the number located on the label of the module
- Confirm entry
- 10. If the displayed number is correct confirm and coding will begin A message "Coding Complete" will be displayed when finished coding.