OUTER CV JOINT, INSTALLING
Before installing CV joint or triple roller star, splines -A- must be lightly coated with grease used in joint.
Install old drive shaft bolt in joint as shown in the illustration.
Drive joint onto shaft with plastic hammer until circlip engages.
Inner CV joint, Disassembling and Assembling
Scheme 207
Drive cover down with copper or brass drift.
Scheme 208
Drive out CV joint boot with a drift.
Support ball hub when pressing off.
Before installing CV joint or triple roller star, splines -A- must be lightly coated with grease used in joint.
Scheme 209
Press on joint until stop.
Install circlip.
Note. Chamfer on inner diameter of ball hub (splines) must face the contact shoulder on the drive axle.