ACCESSORY ASSEMBLY BRACKET
Special tools and workshop equipment required
- Locking Pin T10060A
Removing
Disconnect the electrical connector on the mass airflow (MAF) sensor -G70- -3-.
Open clips -1 and 2- and remove air guide hose from MAF sensor.
Remove front air intake connector on lock carrier -4-.
Remove engine cover.
Pull the Evaporative Emission (EVAP) canister with connected lines upward -arrow- out of the retainer and lay it aside.
Note. Before removing the ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed turning direction can cause damage to the belt under operating conditions.
Pivot the ribbed belt tensioner in direction of -arrow- to relieve tension on ribbed belt.
Secure tensioning element using the T10060A.
Remove ribbed belt.
Remove ribbed belt tensioner -arrows-.
Scheme 201
Discharge the refrigerant circuit. Refer to Description and Operation .
Remove the generator. Refer to [For transmission(s) 02E] Removal and Installation
Remove center noise insulation fasteners -1 to 4-.
Scheme 202
Remove the right noise insulation -arrows-.
Scheme 203
Remove noise insulation frame -arrow-.
Scheme 204
Remove the A/C compressor. Refer to Removal and Installation .
Remove the accessory assembly bracket - bolts -1 through 6-.
Installing
Installation is performed in the reverse order of removal, noting the following.
- For the correct tightening specifications, refer to «RIBBED BELT AND ASSEMBLY BRACKET OVERVIEW»(/audi/tt/8j-2006-2010/remont/mechanical/#20l-crankshaft-cylinder-block-engine-codes-bpy-coupe__ribbed-belt-and-assembly-bracket-overview) .
Tighten the bolts in the sequence -1 through 6-.
Install the generator. Refer to [For transmission(s) 02E] Removal and Installation
Install A/C compressor. Refer to Removal and Installation .
Install the ribbed belt. Refer to RIBBED BELT .
Connect the battery. Refer to [For transmission(s) 02E] Removal and Installation .