Home ReviewsRefund
Home/Audi/S5/Audi S5 I facelift (2011-2016)/Repair manual/Rear Final Drive 0BF & 0BE (Cabriolet)/INSTALLING
Contents Wiring diagrams Section: Rear Final Drive 0BF & 0BE (Cabriolet) All sections

INSTALLING Audi S5 I facelift

Rear Final Drive 0BF & 0BE (Cabriolet) ~185 words

INSTALLING

  1. The ball -5-, the guide -4- (the smaller diameter faces the spring) and the spring -3- must be installed in the opening inside the housing -6- for the clutch valve -- -2-.

Coat the new O-rings -arrows- with ATF and install the clutch valve --.

Pre-tighten the bolts -1- evenly hand-tight. Then tighten them to the tightening specification, refer to item 13 .

Further installation is in the reverse sequence to removal. Note the following when doing this

Note. Connector allocation for the oil pressure/temperature sensor -- and the clutch valves -- : -1- = oil pressure/temperature sensor 2 -G640- connector -2- = oil pressure/temperature sensor -G437- connector -3- = AWD clutch valve 2 -N446- connector -4- = AWD clutch valve -N445- connector

Attach the wiring harness bracket to the rear final drive. (Scheme 457)

Fill the ATF in the rear final drive. Refer to ATF IN REAR FINAL DRIVE 0BF AND 0BE, FILLING .

Install the rear section of the exhaust system free of tension. Refer to [For engine(s) CCBA] Description and Operation or to [For engine(s) CAEB] Description and Operation .