CONNECTING
Airbag connectors are connected in the following sequence, note the following
| WARNING | Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS . Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin. |
Note. Make sure the connectors are installed all the way in and are secure.
| WARNING | Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery. |
Connect the battery ground (GND) cable with the ignition turned on. Refer to [For engine(s) CAUA,CAEB,CALA] Removal and Installation .
Note. If the airbag indicator lamp -K75- indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the vehicle diagnostic tester.