Home/Audi/S4/Audi S4 B8 (2008-2011)/Repair manual/Rear Final Drive 0ar/Securing rings

Contents

Wiring diagrams Section: Rear Final Drive 0ar

Identification of rear final drive

Code letters, aggregate allocation, ratios, capacities, Audi A4 2002 >, Cabriolet 2003 >

Code letters, aggregate allocation, ratios, capacities, Audi A6 2005 >

Code letters, aggregate allocation, ratios, capacities, Audi A8 2004 >

Power transfer, overview

General Repair Notes

Vehicle jack mode on vehicles with air spring suspension

O-rings, gaskets, seals

Securing rings

Nuts, bolts

Driveshaft, servicing overview

Driveshaft (Audi A4 and Cabriolet, Audi A6), removing and installing

Driveshaft (Audi A4 and Cabriolet, Audi A6), removing

Installing driveshaft - Audi A4 and Cabriolet, Audi A6

Driveshaft, removing and installing - Audi A8

Removing driveshaft - Audi A8

Installing driveshaft - Audi A8

Driveshaft, disconnecting from rear final drive

Driveshaft, securing to rear final drive

Measure radial play at flange/driveshaft and mark

Axle oil in rear final drive, checking

Rear final drive, removing and installing

Rear final drive (Audi A4 and Cabriolet, Audi A6), removing and installing

Installing rear final drive - Audi A4 and Cabriolet, Audi A6

Rear final drive (Audi A8), removing and installing

Installing rear final drive - Audi A8

Oil seals for flange shafts, replacing

Sealing ring for flange/driveshaft (rear final drive installed), replacing

All sections

Securing rings Audi S4 B8

Rear Final Drive 0ar 1 illustration

Securing rings

Do not over-stretch circlips.
Always replace damaged or over-stretched circlips.
Securing rings must be fully seated in groove.

Scheme 103

Scheme 103

Scheme 103

Replace roll pins. Installation position: Slot - A - is longitudinal to line of force - arrow -.