Home/Audi/S4/Audi S4 B7 (2004-2008)/Repair manual/Body Exterior/"Zero" position (link guide), adjusting

Contents

Wiring diagrams Section: Body Exterior

Lock carrier, service position

Lock carrier with attachments, removing and installing

Fender, removing and installing

Hood, removing, installing and adjusting

Hood gap dimensions

Hood lining, removing and installing

Hood seal, assembly overview

Impact guard, installing

Striker, removing and installing

Gap dimensions for rear lid

Gap dimensions for fuel filler flap

Rear lid hinge, removing and installing

Gas-filled strut, removing and installing

Fuel filler flap

Rear lid, removing and installing

Rear lid, adjusting

Gas-filled strut for rear lid, removing and installing

Adjustment dimensions for rear lid

Lock cylinder for rear lid, removing and installing

Handle mechanism for rear lid, removing and installing

Rear lid lock, removing and installing

Removing lid lock

Rear lid lock actuator, removing and installing

Motor for window regulator, removing and installing

Front door, adjusting

Panel gap dimensions

Adjustment for B-pillar region

Window frame installation

Repairing the central locking system

Window regulator motor, removing and installing

Manual window regulators, removing and installing

Rear door, adjusting

Adjusting using Door adjustment template T40038/1

Door handle, removing

Disengage mount for door handle

Removing trim

Engaging operating rod in door lock

Wind deflector, removing and installing

Sunroof headliner, removing and installing

Trim, removing and installing

Boot, removing and installing (vehicles as of CW 27/2002 >)

Sunroof panel, removing

Panel seal, replacing

"Zero" position (link guide), adjusting

"Zero" position of sunroof motor (link guide), checking and adjusting

Cleaning water drain hoses

Front bumper, removing and installing

Radiator grill, removing and installing

Centering holes for side impact moldings

Bumper, mounting to shock absorber

Guide piece, removing and installing

Crossmember, removing from cover and installing

Two-piece bumper cover, separating

Shock absorber, removing and installing

Bumper, removing and installing

Side impact moldings, replacing

Adhering centering pins on side impact molding

Crossmember for bumper, removing and installing

Crossmember for bumper (vehicles with trailer hitch), removing and installing

Servicing windows using special tool

Materials

Minimum curing times!

Removing

Preparing for window installation

Windshield, installing

Undamaged side window, removing

Side window, installing

Undamaged rear window, removing

Damaged rear window, removing

Installing rear window

Assembly overview

Roof trim molding (Sedan), removing and installing

Roof trim molding, removing and installing (Avant)

Disengaging roof trim molding from trim molding under side window

Replacing side protective moldings

Window weatherstrips for front door (standard vehicle), removing and installing

Front window weatherstrips (vehicles with gloss package), removing and installing

Window weatherstrips for rear door (standard vehicle), removing and installing

Rear window weatherstrips (vehicles with gloss package), removing and installing

Outside rear view mirror, removing and installing

Outside rear view mirror adjusting motor, removing and installing

Outer sill panel trim, replacing

Underbody covers

Wheel spoiler

Lettering on rear lid (Sedan)

Lettering on rear lid (Avant)

Rear lid spoiler, removing and installing

All sections

"Zero" position (link guide), adjusting Audi S4 B7

Body Exterior

"Zero" position (link guide), adjusting

Motor is removed, electrical harness connections connected.
Move rotary control to "roof closed" position.
Sunroof motor runs to "zero" position and cuts out automatically
Install motor in this position with sunroof closed