FASTENER TIGHTENING SPECIFICATIONS
| Component | Bolt Size | Nm |
|---|---|---|
| Bracket for the Electrical Wiring Harness | 9 | |
| Bracket for the Oil Filter Housing | 9 | |
| Cap for Oil Filter Housing | 35 | |
| Chain Sprocket for Oil Pump | 60 | |
| Engine Oil Cooler | 9 | |
| Guide Tube for Oil Dipstick | 9 | |
| Locking Bolt for the "TDC" Marking | 35 | |
| Mounting Plate | 9 | |
| Oil Baffle (1) | 8 + 90° | |
| Oil Drain Plug | 30 | |
| Oil Pressure Regulation Valve | 9 | |
| Oil Pressure Switch | 20 | |
| Oil Pump | 23 | |
| Oil Return Pipe | 9 | |
| Oil Supply Pipe to Turbocharger | 9 | |
| Pressure Regulator Valve for the Crankshaft Housing Ventilation | 9 | |
| Reduced Oil Pressure Switch | 20 | |
| Upper Coolant Pipe, Nut | 9 | |
| (1) Always replace | ||
| (1) | Always replace |
Oil Level Thermal Sensor -G266- Tightening Specification
Tighten the nuts -1- to 9 Nm.
Lower Section of Oil Pan, Tightening Specifications and Sequence
Note. Replace bolts which have been tightened to an additional torque.
Tighten bolts in 3 stages as follows
| Step | Tightening Torque/Additional Angle of Rotation |
|---|---|
| 1. | 5 Nm in a diagonal sequence |
| 2. | 8 Nm in a diagonal sequence |
| 3. | In a diagonal sequence, turn an additional 90° |
Upper Oil Pan, Tightening Specifications and Sequence
Tighten bolts in 2 stages as follows
| Step | Bolt | Tightening Specification |
|---|---|---|
| 1. | 1 through 4 | 5 Nm in a diagonal sequence |
| 2. | 1 through 4 | 15 Nm in a diagonal sequence |