Note. Whenever a glass panel, a motor, the slotted guide rail or the sun shade is removed, it is necessary to perform an adaptation for the appropriate drive. If new motors have been installed, then the adaptation process will start 10 seconds after the switch has been activated. Pinch protection is switched off when performing an adaptation.
Power sunroof control module -J245- adaptation
The ignition is switched on.
The sunroof regulator -E139- must be in the "sunroof closed" position.
Pull the sunroof regulator -E139- -1- down -arrow- and hold it steady in this position for the entire adaptation process (about 20 seconds).
Scheme 1
During the adaptation process, the glass sunroof will first close and then retract by approximately 200 mm.
Let go of the sunroof regulator -E139- after the sunroof closes again and the adaptation procedure has completed.
Roof blind control module -J394- adaptation
The ignition is switched on.
Press the folding sunroof button 1 -E584- >>close sunshade<< -2- and hold it in this position for the entire adaptation process (about 20 seconds).
During the adaptation process, the sunshade will first close and then retract by approximately 200 mm.
Release the folding sunroof button 1 -E584- after the sunshade has closed again; the adaptation process is now complete.
Scheme 2
- Sunroof Motor Removing and Installing, refer to «POWER SUNROOF CONTROL MODULE»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof) Adaptation, refer to «SUNROOF ADAPTATION»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof)
- Assembly frame Assembly overview, refer to «ASSEMBLY FRAME ASSEMBLY OVERVIEW»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof) Removing and Installing, refer to «ASSEMBLY FRAME ASSEMBLY OVERVIEW»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof)
- Slotted guide rail Removing and Installing, refer to «FRONT GLASS PANEL SLOTTED GUIDE RAIL AND CABLE»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof__front-glass-panel-slotted-guide-rail)
- Wind Deflector Removing and Installing, refer to «WIND DEFLECTOR»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof__wind-deflector)
- Outer seal Replace, refer to «OUTER SEAL»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof__outer-seal)
- Bolt 4.5 Nm
- Rear glass panel Removing and Installing, refer to «REAR GLASS PANEL»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof__rear-glass-panel) Adjusting, refer to «FRONT AND REAR GLASS PANEL HEIGHT, ADJUSTING»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof__front-and-rear-glass-panel-height)
- Front glass panel Removing and Installing, refer to «GLASS PANEL»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof__glass-panel) Adjusting, refer to «FRONT AND REAR GLASS PANEL HEIGHT, ADJUSTING»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof__front-and-rear-glass-panel-height)
- Bolt 4.5 Nm
- Sunshade motor Removing and Installing, refer to «ROOF BLIND CONTROL MODULE»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof__roof-blind-control-module) Adaptation, refer to «SUNROOF ADAPTATION»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof)
- Bolt 2 Nm
- Bolt 3.5 Nm
- Sun Shade Removing and Installing, refer to «SUN SHADE»(/audi/q5/i-2008-2012/remont/sun-rooft-topconvertible-top/#sunroof__sun-shade)