INSTALLING
Install the rubber bonded bushing into the sleeve T40184/3. The "thin" collar -arrow- must face upward.
In order to install the rubber bonded bushing, T40184/2 -3- must be mounted on the rubber bonded bushing in such a way that lugs -2- fit into grooves -4-.
Press the rubber bonded bushing all the way onto the thrust plates -1- and -6-.
Scheme 98
- VW 401. Order as illustrated.
- T40184/3
- Bonded rubber mount
- VW 408 A
- T40184/2
- VW 402. Order as illustrated.
Then slightly pull apart the thrust plates -1- and -6-.
Press the rubber bonded bushing approximately 2 mm out of the T40184/3.
Scheme 99
a- = 2 mm
Pull off the VW 408 A and install the VW 411.
Mount the wheel bearing housing onto the V.A.G 1290 A.
Mount the rubber bonded bushing (not shown in the illustration), pressure plate -3- and sleeve -1- on the wheel housing bearing.
Scheme 100
- Sleeve T40184/5
- VW 411
- T40184/2. Pay attention to the installation position on the bonded rubber bushing.
Place the tools on the bonded rubber bushing and the wheel bearing housing -3- as illustrated.
Scheme 101
Slowly press the rubber bonded bushing in (not shown in the illustration) until the sleeve -2- can be pulled out at the top.
- VW 411
- T40184/3
- Wheel Bearing Housing
- T40184/1. The side with the groove must face the wheel bearing housing. On a bonded rubber bushing with a "positioning tab", this is in the groove on the T40184/1.
- VW 402
Ignore item -3-.
Scheme 102
Slowly press the rubber bonded bushing -2- so that it is even with the edge -arrow- of the wheel bearing housing.
Install wheel bearing housing. Refer to WHEEL BEARING HOUSING .