Home/Audi/Q5/Audi Q5 I (2008-2012)/Repair manual/3.2l - Fuel Injection System - Engine Code(s): Calb/FUEL PRESSURE SENSOR

Contents

Wiring diagrams Section: 3.2l - Fuel Injection System - Engine Code(s): Calb

SAFETY PRECAUTIONS

CLEAN WORKING CONDITIONS

ON BOARD DIAGNOSTICS

BEFORE OPENING HIGH PRESSURE FUEL INJECTION SYSTEM

COMPONENT LOCATIONS OVERVIEW

OXYGEN SENSORS OVERVIEW

FASTENER TIGHTENING SPECIFICATIONS

TECHNICAL DATA

FUEL PRESSURE AND RESIDUAL PRESSURE BEFORE HIGH PRESSURE PUMP, CHECKING

FUEL SYSTEM, PERFORMING LEAK TEST

VACUUM SYSTEM, CHECKING

WIRING AND COMPONENTS, CHECKING WITH TEST BOX VAG 1598/42

AIR FILTER ELEMENT

LOWER AIR FILTER HOUSING

UPPER INTAKE MANIFOLD

LOWER INTAKE MANIFOLD WITH FUEL RAIL

FUEL PRESSURE SENSOR

HIGH PRESSURE PUMP

FUEL INJECTORS

HIGH PRESSURE LINES

HEATED OXYGEN SENSOR -G39

OXYGEN SENSOR AFTER THREE WAY CATALYTIC CONVERTER -G130

OXYGEN SENSOR 2 AFTER CATALYTIC CONVERTER -G131

HEATED OXYGEN SENSOR 2 -G108

ENGINE CONTROL MODULE

SPECIAL TOOLS

All sections

FUEL PRESSURE SENSOR Audi Q5 I

3.2l - Fuel Injection System - Engine Code(s): Calb

FUEL PRESSURE SENSOR

Removing

Remove upper section of the intake manifold. Refer to UPPER INTAKE MANIFOLD .

Disconnect electronic connector from the fuel pressure sensor -G247- -4-.

Remove fuel pressure sensor -G247- -4-.

Installing

Installation is in reverse order of removal.

Tightening Specifications. Refer to «LOWER INTAKE MANIFOLD WITH FUEL RAIL OVERVIEW»(/audi/q5/i-2008-2012/remont/fuel-system/#32l-fuel-injection-system-engine-codes-calb)

Install upper section of the intake manifold. Refer to UPPER INTAKE MANIFOLD .