Home ReviewsRefund
Home/Audi/A8/Audi A8 D2 рестайлинг (1999-2002)/Repair manual/Disc Brakes/With Electronic Stability Program
Contents Section: Disc Brakes All sections

With Electronic Stability Program Audi A8 D2 рестайлинг

Disc Brakes ~188 words

With Electronic Stability Program

Note. Electronic Stability hydraulic unit must be bleed using VAG 1551 or VAG 1552 scan tool.

Note. A positive pressure of 29 psi must be maintained to bleed hydraulic pump. Before beginning bleeding procedure, verify pressure bleeder setting.

  1. Connect pressure bleeder US1116 or equivalent, to master cylinder reservoir. Connect hose to brake caliper bleed screw and insert other end of hose in a clear container 1/4 full of clean brake fluid. Bleed air from brake system in order. See «BRAKELINE BLEEDING SEQUENCE (WITH ESP)»(/audi/a8/d2-1999-2002/remont/mechanical-hydraulic/#disc-brakes) table.
  2. Turn ignition off. Connect scan tool to Data Link Connector (DLC). DLC is located in center console behind ash tray. Bleeding of hydraulic unit is accomplished with scan tool in BASIC SETTINGS mode. Following scan tool instructions, navigate to BASIC SETTINGS mode. Connect hose to left front caliper bleeder screw, and insert other end of hose in a clear container 1/4 full of clean brake fluid.
  3. Using scan tool command hydraulic pump on. Pump should run for 10 seconds. Repeat procedure until brake fluid runs clear with no air bubbles.
ApplicationSequence
A8 & S8LR, RF, RR & LF

BRAKELINE BLEEDING SEQUENCE (WITH ESP)