General Information
For driving safety, do not replace tires individually, instead replace tires by axle (at least).
The tires with the deeper tread should always be on the front wheels.
It is recommended to mount only tires of the same make, structure, and tread pattern on all wheels.
When replacing the disc wheel or the tire, the rubber valve should always be replaced.
Tires are to be installed with DOT markings facing outside of wheel; it applies to left side of vehicle only in case of tires with directional tread pattern.
If the tires are directional, the spare should be a wheel/tire combination for the right side of the vehicle.
Tire pressure control system, component overview
The following list pertains to (Схема №8).
- Antenna 4 x
- Display in instrument panel See «TIRE PRESSURE MONITORING SYSTEM ON BOARD DIAGNOSTIC»(ref-196274-S31068413502005100800000) .
- Tire Pressure Monitoring Control Module -J502- In luggage compartment (left rear) in control module bracket
- Wheel electronics 4 x
Wheels/tires, assembly overview
The following list pertains to (Схема №10).
- Metal valve body Only use valve according to spare parts catalog Is supplied complete Replace valve insert at every tire change Removing and installing, see «METAL VALVE BODY, REMOVING AND INSTALLING»(ref-196276-S04414313582005100800000)
- Valve insert
- Seal Removing and installing, see «METAL VALVE BODY, REMOVING AND INSTALLING»(ref-196276-S04414313582005100800000)
- Rim Tires, removing and installing, see «REMOVING TIRE»(ref-196276-S26934078212006041100000) and «INSTALLING TIRE»(ref-196276-S17260769312006041100000) .
- Wheel electronics Battery service life approx. 7 years Remaining service life can be checked via diagnostic See «TIRE PRESSURE MONITORING SYSTEM ON BOARD DIAGNOSTIC»(ref-196274-S31068413502005100800000) . Must be replaced as a complete assembly Reception antennas, removing and installing, see «REMOVING AND INSTALLING RECEPTION ANTENNAS»(ref-196276-S13241567432005100800000)
- Micro encapsulated bolt (Torx t20) Tightening torque 4Nm., see «METAL VALVE BODY, REMOVING AND INSTALLING»(ref-196276-S04414313582005100800000)
- Union nut Removing and installing Tightening torque 4 Nm.
- Chamfered washer