REMOVING
Raise the vehicle.
Remove the wheels.
Note. When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven!
Remove the caps -13-.
For vehicles with the brake wear pad indicator, disconnect the left front connector -4-.
Lift securing strap slightly at bottom of connector and then rotate 90°.
Remove the lower part of the brake pad wear indicator connector from the bracket.
Using screwdriver, pry off brake pad retaining spring from brake caliper housing and remove.
Scheme 8
Loosen and remove both guide pins -12- from the brake caliper.
Scheme 9
Note. Secure the brake caliper to the vehicle with a suitable wire. Do not support the weight with the brake hose.
Remove brake pads from brake caliper housing or from brake carrier.