Home ReviewsRefund
Home/Audi/A4/Audi A4 B8 (2007-2012)/Repair manual/Wiring - General Information (avant)/THREADED CONNECTIONS, SERVICING
Contents Wiring diagrams Section: Wiring - General Information (avant) All sections

THREADED CONNECTIONS, SERVICING Audi A4 B8

Wiring - General Information (avant) ~267 words

THREADED CONNECTIONS, SERVICING

Special tools and workshop equipment required

  1. Contact Surfaces Cleaning Set VAS 6410

Note. Using the Contact surface cleaning set VAS 6410 VAS 6410, service work can be performed in the area of the contact sensor on the threaded connection wiring harnesses in the high current circuit (starter and charging current). The gray sanding pads are for slight contamination and suitable for "soft surfaces". The red sanding pads are for heavy contamination and suitable for "hard surfaces".

Note. Do not use rust remover, contact spray or grease because the lack of friction will cause the torque to be exceeded when installing and this will lead to the threaded connections breaking.

WARNINGRisk of injury. Follow all Warnings and Safety Precautions. Refer to LEAD-ACID BATTERY WARNINGS AND SAFETY PRECAUTIONS .

Disconnect the battery. Refer to Removal and Installation .

Loosen the cap nut and remove the wiring eyelet from the threaded connection.

Check the threaded connection for corrosion, contamination, etc.

Select the corresponding adapter and the corresponding sanding pad for the threaded connection.

CAUTIONIncreased corrosion due to an exposed copper layer. Make sure the tin layer is not worn down too much and the copper is not visible. Increased corrosion can result due to the galvanizing effects.

Note. Due to the different thicknesses of the tin layer, the cleaning process must be performed in several steps and a visual inspection of the threaded connection between steps is necessary.

Insert the adapter in the threaded connection and sand off the corrosion and contamination with circular motion.

Check the threaded connection and sand it again if necessary.

Tighten the connection and, if necessary, the anti-rotation protection to the tightening specification.

Note. Optimal contact is ensured if the bolted components are tightened to the specified torque after cleaning.

Protect the connection with the corresponding protection material. Refer to PROTECTING .

Reconnect the battery. Refer to Removal and Installation .