Home ReviewsRefund
Home/Audi/A4/Audi A4 B8 (2007-2012)/Repair manual/Exterior Lights, Switches (sedan)/STEERING COLUMN SWITCH MODULE
Contents Wiring diagrams Section: Exterior Lights, Switches (sedan) All sections

STEERING COLUMN SWITCH MODULE Audi A4 B8

Exterior Lights, Switches (sedan) 2 illustrations ~161 words

STEERING COLUMN SWITCH MODULE

Removing

Adjust the steering wheel downward and to the rear as far as possible, use the entire adjustment range of the steering column adjustment for this.

Remove the driver airbag. Refer to Removal and Installation .

Remove the steering wheel. Refer to Removal and Installation .

Remove the steering column trim. Refer to Removal and Installation .

Remove the bolt -1-.

Scheme 122

Scheme 122: STEERING COLUMN SWITCH MODULE
Scheme 122: STEERING COLUMN SWITCH MODULE

Disconnect the electrical connector -2-.

WARNINGThe technician must discharge static electricity before disconnecting the electrical connector -3-, for example by touching the door striker pin.

Disconnect the electrical connector -3-.

Press the catch -1- in the -direction of the arrow- until the harness connector -2- disengages.

Scheme 123

Scheme 123
Scheme 123

Carefully remove the steering column switch module.

Installing

  1. Tightening specification, refer to «STEERING COLUMN SWITCH MODULE AND ELECTRONIC IGNITION LOCK OVERVIEW»(/audi/a4/b8-2007-2012/remont/exterior-lights/#exterior-lights-switches-sedan__steering-column-switch-module-and-electronic) .

Install in reverse order of removal, observing the following

Install the steering column trim. Refer to Removal and Installation .

Install the steering wheel. Refer to Removal and Installation .

Install the driver airbag. Refer to Removal and Installation .