Home ReviewsRefund
Home/Audi/A4/Audi A4 B8 (2007-2012)/Repair manual/Controls, Housing (Continuously Variable Transmission 0aw (sedan))/1. SELECTOR MECHANISM FUNCTION TEST
Contents Wiring diagrams Section: Controls, Housing (Continuously Variable Transmission 0aw (sedan)) All sections

1. SELECTOR MECHANISM FUNCTION TEST Audi A4 B8

Controls, Housing (Continuously Variable Transmission 0aw (sedan)) ~425 words

1. SELECTOR MECHANISM FUNCTION TEST

  1. Never operate the starter when the selector lever is in "S", "D", "R" and the "tiptronic gate".
  2. If selector lever position "N" is selected at speeds greater than 5 km/h, the shift lock solenoid must not engage and block the selector lever. The selector lever can be moved into a another gear.
  3. For speeds below 2 km/h (almost standstill) and shifting into selector lever position "N", the shift lock solenoid must only engage after approximately 1 second. The selector lever can be moved out of "N" only when the brake pedal is pressed.

Selector lever in "P"

Press the button on the parking brake to activate it.

To reach the position "ignition on", slightly tilt the key in the ignition lock.

Do not press the brake pedal.

  1. Selector lever is locked and cannot be shifted out of position "P" while locking the button on selector lever handle is pressed. The shift lock solenoid -N110- locks the selector lever.

Press the brake pedal and hold it down.

  1. The shift lock solenoid unlocks the selector lever. It is not possible to shift into a gear. Press the button in the selector lever handle and slowly move the selector lever from "P" and through "R, N, D/S". While doing this, make sure the transmission range display -Y6- inside the instrument cluster matches the actual position of the selector lever.

The selector lever is in "N" and the ignition is turned on

Do not press the brake pedal.

  1. After a short waiting period: The selector lever is locked and cannot be moved out of the "N" position despite pressing the locking button on selector lever handle. The shift lock solenoid locks the selector lever.

Press the brake pedal.

  1. The shift lock solenoid unlocks the selector lever. It is possible to shift into "D".

The selector lever is in "D" and the ignition is on

Move the selector lever into the "tiptronic gate".

  1. The "D" in the selector lever transmission range position display unit -Y26- must turn off and the "+" and "-" must turn on.
  2. The transmission range display inside the instrument cluster must change from "D" to "M1" when the selector lever moves into the "tiptronic gate".

If the specified value is not reached, perform a "Guided Fault Finding", refer to vehicle diagnostic tester.

Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, ADJUSTING .

Selector lever handle locking button, checking, refer to CHECK LOCKING BUTTON IN THE SELECTOR LEVER HANDLE .

Check the ignition key lock.