Adjustment overview
Note. If performing assembly work on the final drive it is only necessary to adjust the drive pinion or final drive set if components have been replaced which have a direct effect on the adjustments of the final drive. To eliminate unnecessary adjustments observe following table
| To adjust | |||
|---|---|---|---|
| Parts replaced: ↓ | Ring gear "S1"+"S2" 1) Refer to Ring gear, adjusting | Pinion shaft "S3" 1) Using deviation "r" Refer to Drive pinion, adjusting | Backlash Testing Refer to Adjusting backlash |
| Final drive housing | X | X | X |
| Differential housing | X | X | |
| Taper roller bearings for pinion shaft | X | X | |
| Taper roller bearing for differential | X | X | |
| Final drive set 2) | X | X | X |
| Final drive cover | X | X | |
1) Shims; installation position. Refer to Position of shims .
2) Drive pinion and ring gear; only replace together.