BACKREST LOCK ACTUATING LINK
Special tools and workshop equipment required
- Pop Rivet Pliers VAS 5072
- Drill
- Drill bit ø 6.0 mm
Removing
Remove the seat. Refer to SEAT .
Secure the seat on the VAS 6136. Refer to FRONT SEAT, INSTALLING ON VAS 6136 .
Remove backrest and front seat pan. Refer to FRONT BACKREST AND SEAT PAN .
Remove backrest cover. Refer to BACKREST COVER AND UPHOLSTERY .
Remove bolts -arrows- on inner part of belt guide.
Scheme 93
Remove inner part of belt guide -1-.
Rotate inner part of belt guide and release retaining tabs -arrows-.
Scheme 94
Remove cover -1-.
Remove bracket -3- for backrest lock actuating link on inner part of belt guide.
Scheme 95
Remove backrest lock release lever -2-.
Disengage actuating link -1- in -direction of arrow-.
Repeat work steps on opposite side.
Remove backrest cover and backrest frame. Refer to BACKREST COVER .
Scheme 96
Remove screws -3 and 4-.
Drill out pop rivet -2- with a ø 6.0 mm drill in backrest frame mount -1-.
Tip backrest frame mount to side, remove actuating link bracket -2- at backrest frame mount -3-.
Scheme 97
Disengage actuating link eye -1- at backrest lock release lever -4- by sliding eye forward -arrow- and removing.
Remove actuating link upward from backrest frame.
Installation
Installation is reverse of removal, but note the following
Insert the bolts with locking compound; locking compound.
Adjust backrest lock actuating link. Refer to BACKREST LOCK ACTUATING LINK, ADJUSTING .