SIDE TRIM
| WARNING | Follow the safety precautions for pyrotechnic components. Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin. |
Scheme 84
- Bolt 1.2 Nm
- Sill Side Trim Removing -- Remove the seat. Refer to «SEAT»(/audi/a3/8p-2004-2008/remont/seats/#seat-frames) . -- Secure the seat on the VAS 6136. Refer to «FRONT SEAT, INSTALLING ON VAS 6136»(/audi/a3/8p-2004-2008/remont/seats/#seat-frames__front-seat-installing-on-vas-6136) . -- Remove backrest adjustment hand wheel -5-. -- Remove seat height adjustment handle -7-. Refer to «SEAT HEIGHT ADJUSTMENT HANDLE»(/audi/a3/8p-2004-2008/remont/seats/#seat-frames) . -- Remove expanding clip -6-, press clamping pin through to the inside. -- Remove mounting bolt -1-. -- Remove side panel -2- at lower edge from retaining bracket on seat. -- Swing side panel upward at front edge. -- Remove side panel to side. -- Pull tab at rear of side panel out under backrest trim. Installation To install, perform the steps used in removal in reverse order.
- Tunnel Side Trim Removing -- Remove the seat. Refer to «SEAT»(/audi/a3/8p-2004-2008/remont/seats/#seat-frames) . -- Secure the seat on the VAS 6136. Refer to «FRONT SEAT, INSTALLING ON VAS 6136»(/audi/a3/8p-2004-2008/remont/seats/#seat-frames__front-seat-installing-on-vas-6136) . -- Remove expanding clip -4-, press clamping pin through to the inside. -- Disengage retaining detent at rear side of side panel on tunnel side. -- Remove the trim. Installation To install, perform the steps used in removal in reverse order.
- Spreader Clip
- Hand Wheel for Backrest Adjustment Removing and Installing, refer to «BACKREST ADJUSTMENT HAND WHEEL»(/audi/a3/8p-2004-2008/remont/seats/#seat-frames__backrest-adjustment-hand-wheel)
- Spreader Clip
- Seat Height Adjustment Handle Removing and Installing, refer to «SEAT HEIGHT ADJUSTMENT HANDLE»(/audi/a3/8p-2004-2008/remont/seats/#seat-frames)