Home ReviewsRefund
Home/Audi/A3/Audi A3 8P рестайлинг (2004-2008)/Repair manual/3.2l - Cylinder Head, Valvetrain - Engine Code(s): Bub & Cbra/Removing
Contents Section: 3.2l - Cylinder Head, Valvetrain - Engine Code(s): Bub & Cbra All sections

Removing Audi A3 8P рестайлинг

3.2l - Cylinder Head, Valvetrain - Engine Code(s): Bub & Cbra 1 illustration ~144 words

Removing

  1. Engine installed.

Note. All cable ties which are opened or cut open when removing, must be replaced in the same position when installing. Heat shield boots that were removed should be installed in the same location during installation.

Remove camshaft timing chain from camshafts. Refer to CAMSHAFT TIMING CHAIN .

Remove control housing -arrows-.

Scheme 87

Scheme 87
Scheme 87

Carefully pull control housing off camshaft seals.

Remove intake camshaft -A- as follows

  1. Remove bearing caps 1 and 13.
  2. Remove bearing caps 3 and 11.
  3. Remove bearing cap 7.
  4. Loosen bearing caps 5 and 9 alternately and in diagonal sequence, and remove.

Remove exhaust camshaft -B- as follows

  1. Remove bearing caps 2 and 14.
  2. Remove bearing caps 4 and 12.
  3. Remove bearing cap 8.
  4. Loosen bearing caps 6 and 10 alternately and in diagonal sequence, and remove.

Carefully remove camshafts and place on a clean surface.