Power Windows: Maintenance Acura RSX I facelift

Resetting the Power Window Control Unit

Resetting the power window control unit is required after performing the following procedures

1. Disconnecting the battery
2. Removing the No. 6 (7.5 A) and/or the No. 23 (20 A) fuses in the under-dash fuse/relay box
3. Disconnecting the driver's door wire harness
4. Disconnecting the power window control unit

1. Turn the ignition switch ON (II).
2. Move the driver's window all the way down holding the driver's switch in the AUTO DOWN position; when the window reaches the bottom, hold the driver's window switch in the AUTO DOWN position for 2 seconds.
3. Move the driver's window all the way up holding the driver's switch in the AUTO UP position; when the window reaches the top, hold the driver's window switch in the UP position for 2 seconds.
4. If the window does not work in AUTO, repeat steps 1 through 3.

Scheme 83

Scheme 84

1. Remove the passenger's door panel (see «DOOR PANEL REMOVAL/INSTALLATION»(ref-218804-S07413733482006021000000) ).
2. Disconnect the 2P connector (A) from the passenger's power window motor.
3. Test the motor in each direction by connecting battery power and ground according to the table. NOTE: To prevent damage to the motor, disconnect one lead as soon as the motor stops running.
4. If the motor does not run or fails to run smoothly, replace it.