Home/Acura/RL/Acura RL II (2004-2008)/Repair manual/Audio System/Audio disc does not eject

Contents

Wiring diagrams Section: Audio System

General information

Symptom Troubleshooting Index

Overview

Audio Unit Connector for Inputs and Outputs

Stereo Amplifier Connector for Inputs and Outputs

AcuraLink Control Unit (XM Receiver) Connector for Inputs and Outputs (With AcuraLink)

XM Receiver Connector for Inputs and Outputs (Without AcuraLink USA models)

Active Noise Control Unit Connector for Inputs and Outputs

Active Noise Control Microphone Connector for Inputs and Outputs

Audio-HVAC Subdisplay Unit Connector for Inputs and Outputs

Interface Dial Connector for Inputs and Outputs

Auxiliary Jack Assembly Connector for Inputs and Outputs ('07-08 models)

Self-diagnostic Function

How to exit the self-diagnosis mode

How to Obtain the Audio Unit Serial Number

LCD lighting mode

LCD lights-out mode

LCD back-up light lighting/lights-out mode

Climate control system communication check mode

Audio amplifier communication check mode

Active Noise Control (ANC) system check mode

How to check the active noise control system in this check mode

Error Codes

Poor AM or FM radio reception or interference

Power switch will not turn ON (No information display and no sound)

Radio stays powered with the ignition switch OFF

No sound is heard from speaker(s) (display is normal)

Poor or no sound with XM radio (Audio unit does display XM channels)

XM radio display is blank and no station information is displayed (with AcuraLink)

XM radio display is blank and no station information is displayed (without AcuraLink)

XM radio preset memory is lost (with AcuraLink)

XM radio preset memory is lost (without AcuraLink)

Audio disc does not eject

Radio preset memory is lost

Audio unit button illumination does not work

Audio disc changer does not load all six discs

Audio disc changer does not move between discs

Volume does not change

Radio tuner does not change stations

Audio disc does not load

Audio disc does not play

Audio disc skips

Audio remote switch does not work properly

Error code: XM NO SIGNAL is displayed

Error code: XM ANTENNA is displayed

Booming sound while driving with audio unit on or off

Sound Quality Diagnosis

Left/Right Channel ID

Phase Test

Electrical Noise Test

Individual Speaker Test

Sound Balance Test

Frequency Sweep

Sound Judging

Seek Stop Test

Audio Unit Removal/Installation

Audio-HVAC Subdisplay Unit Removal/Installation

Front Center Speaker

AcuraLink Control Unit (XM Receiver) Removal/Installation

AM/FM Antenna Repair

All sections

Audio disc does not eject Acura RL II

Audio System ~114 words

Audio disc does not eject

Note. Disc labels should not be used in the audio unit. They may damage the player mechanism. Check the vehicle battery condition first. Always check the connectors for poor connection or loose terminals.

Turn the ignition switch to ON (II).
Turn on the audio system. Does the system turn on? YES - Go to step 3. NO - Go to «POWER SWITCH WILL NOT TURN ON»(/acura/rl/ii-2004-2008/remont/entertainment-systems/#audio-system__power-switch-will-not-turn-on) .
Check to see if the disc ejects correctly with no binding by pushing the EJECT button. Does the disc eject properly? YES - Operation is normal. NO - Replace the audio unit (see «AUDIO UNIT REMOVAL/INSTALLATION»(/acura/rl/ii-2004-2008/remont/entertainment-systems/#audio-system__audio-unit-removalinstallation) ).