Toyota Venza I facelift (2012-2017) intake air control valve actuator Wiring diagram
This page shows the only wiring diagram for the component.intake air control valve actuator, which is found in the car Toyota Venza I facelift (2012-2017). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram intake air control valve actuator (1 of 1)
AIR FUEL RATIO SENSOR (BANK 1 SENSOR 1)
BLK WIRE
BLK/RED WIRE
BLU WIRE
BLU/BLK WIRE
BLU/RED WIRE
BLU/WHT WIRE
BLU/YEL WIRE
BRN WIRE
CRANK POSITION SENSOR
E.F.I. ENGINE COOLANT TEMPERATURE SENSOR
EKNK
EPPM
ETHA
FUEL INJECTOR ASSEMBLY 1
FUEL INJECTOR ASSEMBLY 2
FUEL INJECTOR ASSEMBLY 3
FUEL INJECTOR ASSEMBLY 4
GRN WIRE
GRN/BLK WIRE
IGF
IGNITION COIL ASSEMBLY 1
IGNITION COIL ASSEMBLY 2
IGNITION COIL ASSEMBLY 3
IGNITION COIL ASSEMBLY 4
INTAKE AIR CONTROL VALVE ACTUATOR
INTAKE MASS AIR FLOW METER SUB-ASSEMBLY
LT GRN WIRE
NCA WIRE
NE+
OUT
OXYGEN SENSOR (BANK 1 SENSOR 2)
PNK WIRE
PPMP
RED WIRE
RED/BLU WIRE
RED/WHT WIRE
THA
TOP OF ENGINE)
VCIA
VCPP
VDD
VIO WIRE
VVE-
VVI+
VVT SENSOR (BANK 1 EXHAUST SIDE)
VVT SENSOR (BANK 1 INTAKE SIDE)
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
WHT/RED WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> Wiring diagram engine performance 2.7l (4 of 4) -> INTAKE AIR CONTROL VALVE ACTUATOR
