Toyota Venza I facelift (2012-2017) gnd pnk sil Wiring diagram
This page shows the only wiring diagram for the component.gnd pnk sil, which is found in the car Toyota Venza I facelift (2012-2017). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram gnd pnk sil (1 of 1)
2.7L 3.5L
ACCESSORY METER ASSEMBLY
BLK WIRE
BLU WIRE
BRAKE ACTUATOR ASSEMBLY
BRN WIRE
COMBINATION METER ASSEMBLY
COMPUTER DATA LINES SYSTEM
DOME FUSE
DRIVER SIDE J/B ASSEMBLY
ECU-IG 2 FUSE
ENGINE ROOM R/B
GAUGE 2 FUSE
GND PNK SIL WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
IND
LT GRN WIRE
MICRO -
PNK SPD WIRE
PNK WIRE
POWER
PROCESSOR
RED WIRE
RIGHT END OF DASH)
SUPPLY CIRCUIT/
TACH
TIRE PRESSURE IND
TIRE PRESSURE WARNING ANTENNA, RECEIVER
TIRE PRESSURE WARNING ECU
TIRE)
VIO WIRE
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Tire pressure monitoring circuit -> GND PNK SIL WIRE
