Toyota Venza I (2008-2012) transmission control ecu Wiring diagram
This page shows the only wiring diagram for the component.transmission control ecu, which is found in the car Toyota Venza I (2008-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram transmission control ecu (1 of 1)
2.7L 3.5L
ALT FUSE
ASSEMBLY
ASSEMBLY (LEFT FRONT OF ENGINE COMPT)
BATTERY
BLK WIRE
BLU WIRE
BRN WIRE
DRIVER SIDE J/B ASSEMBLY (LEFT SIDE OF DASH) FUSE
ECM (3.5L: RIGHT REAR OF ENGINE COMPT (2.7L: LEFT SIDE OF ENGINE COMPT)
ENGINE COMPT)
ENGINE ROOM J/B (LEFT SIDE OF
ENGINE ROOM R/B (LEFT SIDE OF ENGINE COMPT)
FUSE
GRN WIRE
IGNITION OR STARTER SWITCH ASSEMBLY
JUNCTION
MAIN FUSIBLE LINK
PARK/NEUTRAL POSITION SWITCH ASSEMBLY (3.5L: LEFT OF ENGINE COMPT) (2.7L: TOP OF
PNK WIRE
RED WIRE
ST RELAY
STARTER ASSEMBLY
TRANSMISSION
TRANSMISSION CONTROL ECU
VIO WIRE
WHT WIRE
WHT/BLK WIRE
Go to component -> Starting circuit, without smart key system -> TRANSMISSION CONTROL ECU
