Toyota Venza I (2008-2012) supply circuit power Wiring diagram
This page shows the only wiring diagram for the component.supply circuit power, which is found in the car Toyota Venza I (2008-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram supply circuit power (1 of 1)
1 2 3 4 5 6 7 8 9 10 11 12 PNK SPD TC TACH IND COMPUTER DATA LINES SYSTEM WIRE
111 110 NE- NE+
2.7L 3.5L
ACCESSORY METER ASSEMBLY
BLK WIRE
BLU WIRE
BRAKE ACTUATOR ASSEMBLY (RIGHT FRONT OF ENGINE COMPT)
BRN WIRE
COMBINATION METER ASSEMBLY
COMPUTER DATA LINES SYSTEM
CRANK POSITION SENSOR (LEFT FRONT OF ENGINE)
DOME FUSE ROOM R/B (LEFT SIDE OF ENGINE COMPT)
DRIVER SIDE J/B
ECM (2.7L: LEFT SIDE OF ENGINE COMPT) (3.5L RIGHT REAR OF ENGINE COMPT)
ECU-IG 2 FUSE
ENGINE
GAUGE 2 FUSE
GND SIL PNK WIRE
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
LT GRN WIRE
NCA WIRE
PNK WIRE
PROCESSOR MICRO-
RED WIRE
SUPPLY CIRCUIT POWER
TACH
TIRE PRESSURE IND
TIRE PRESSURE WARNING ANTENNA, RECEIVER (LEFT REAR "D" PILLAR)
TIRE PRESSURE WARNING ECU (BEHIND GLOVE BOX)
TIRE)
VIO WIRE
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Tire pressure monitoring circuit -> SUPPLY CIRCUIT POWER
