Toyota Venza I (2008-2012) multi-media interface ecu, stereo jack adapter assembly 1 (if equipped) wiring diagram
This page shows the only wiring diagram for the component.multi-media interface ecu, stereo jack adapter assembly 1 (if equipped), which is found in the car Toyota Venza I (2008-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
multi-media interface ecu, stereo jack adapter assembly 1 (if equipped) wiring diagram (1 of 1)
1 2 3 4 5 6 7 8 9 10 FR+ FL+ PNK WIRE
1 2 3 4 5 6 RR+ RL+ RR-
AGND
ALO
ANT
ANTENNA
ARI ASGN ALI AGND AUXI
ARO
ASGN
AUXO
BLK WIRE
BLU WIRE
BRN WIRE
CDR+ CDR- CDL+ CDL- MUTE GND
DRIVER SIDE J/B ASSEMBLY (LEFT SIDE OF DASH)
ENGINE ROOM R/B (LEFT SIDE OF ENGINE COMPT)
FR- FL- GND
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR ACC
ILL- RL-
LEFT REAR SPEAKER ASSEMBLY
LT BLU WIRE
LT GRN WIRE
MAIN ANTENNA
MIC+ MACC
MIC- SGND
MULTI-MEDIA INTERFACE ECU
MULTI-MEDIA INTERFACE ECU, STEREO JACK ADAPTER ASSEMBLY 1 (IF EQUIPPED)
NCA WIRE
ORG/ WIRE
PNK WIRE
RADIO 1 FUSE
RADIO 2 FUSE
RADIO RECEIVER ASSEMBLY
RED WIRE
RIGHT REAR SPEAKER ASSEMBLY
STEREO JACK ADAPTER ASSEMBLY 1
SUB ANTENNA
SWG
TXM- TXM+
ULO+
URO+
VIO WIRE
W/ MULTI-MEDIA INTERFACE ECU
W/O MULTI-MEDIA INTERFACE ECU
WHT WIRE
YEL WIRE
Go to component -> 6-speaker system circuit (1 of 2) -> MULTI-MEDIA INTERFACE ECU, STEREO JACK ADAPTER ASSEMBLY 1 (IF EQUIPPED)
