Toyota Venza I (2008-2012) 6 3 5 3 6 4 cltb clte clts Wiring diagram
This page shows the only wiring diagram for the component.6 3 5 3 6 4 cltb clte clts, which is found in the car Toyota Venza I (2008-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram 6 3 5 3 6 4 cltb clte clts (1 of 1)
13 30 39 PNK STP STPO WIRE
29 29 (3.5L) (2.7L)
6 3 5 3 6 4 CLTB CLTE CLTS
ALT FUSE
AUTOMATIC LIGHT CONTROL SENSOR
BACKUP
BACKUP LAMPS CIRCUIT
BLK WIRE
BLU WIRE
BRAKE ACTUATOR ASSEMBLY (RIGHT FRONT OF ENGINE COMPT)
BRK RELAY
BRN WIRE
CENTER STOP LIGHT ASSEMBLY
CRUISE CONTROL SYSTEM
DOME FUSE HAZ FUSE FUSE
DOOR 1
ECM (3.5L: RIGHT REAR OF ENGINE COMPT (2.7L: LEFT SIDE OF ENGINE COMPT)
ENGINE COMPT)
ENGINE ROOM R/B (LEFT SIDE OF ENGINE COMPT)
GENERATOR ASSEMBLY
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
LEFT REAR COMBINATION LIGHT ASSEMBLY TURN
LEFT REAR LIGHT ASSEMBLY
LICENSE PLATE LIGHT ASSEMBLY
LT BLU WIRE
LT GRN WIRE
MANUAL A/C AUTOMATIC A/C
PNK STP WIRE
PNK WIRE
POWER MANAGEMENT CONTROL ECU (RIGHT SIDE OF DASH)
RED WIRE
RIGHT QUARTER PANEL
RIGHT REAR COMBINATION LIGHT ASSEMBLY TURN STOP
RIGHT REAR LIGHT ASSEMBLY
SHIFT LOCK CONTROL ECU SUB-ASSEMBLY (UNDER CENTER OF DASH)
STOP
STOP LIGHT SWITCH ASSEMBLY
TAIL
TRANSMISSION CONTROL ECU ASSEMBLY (LEFT FRONT OF
VIO WIRE
W/ NAVIGATION SYSTEM W/O NAVIGATION SYSTEM
WHT/BLK WIRE
YEL WIRE
Go to component -> Exterior lamps circuit (1 of 2) -> 6 3 5 3 6 4 CLTB CLTE CLTS
