Toyota Tundra II (2007-2013) (except canh optitron meter) illumination ind canl wiring diagram
This page shows the only wiring diagram for the component.(except canh optitron meter) illumination ind canl, which is found in the car Toyota Tundra II (2007-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(except canh optitron meter) illumination ind canl wiring diagram (1 of 1)
BLU WIRE
CARGO HEADLIGHT ILL- LIGHT LEVELING SWITCH SWITCH (IF EQUIPPED) ILL+
COMBINATION METER
COMPUTER DATA LINES SYSTEM
CONTROL SWITCH
DRIVE MONITOR SWITCH
ENGINE ROOM R/B (LEFT SIDE OF ENGINE COMPT)
FROM J/B 4 (DIAGRAM 1 OF 2)
FROM J/B 5 (DIAGRAM 1 OF 2)
FUSE
GLOVE BOX ILLUMINATION LIGHT
GRN WIRE
GRY WIRE
HAZARD WARNING SIGNAL SWITCH
HOT AT ALL TIMES
HOT IN ON OR START
ILL- SOLID STATE
J/B 4 (LEFT SIDE OF DASH)
J/B 5 (LEFT SIDE OF DASH)
LEFT STEERING SWITCH
LIGHT CONTROL RHEOSTAT
LT BLU WIRE
LT GRN WIRE
MET B FUSE
MET FUSE
ORG/ WIRE
PNK WIRE
POWER CIRCUIT IG+
RED WIRE
RHIG
RIGHT STEERING SWITCH
ROOM LAMP SWITCH
SPIRAL CABLE (LEFT SIDE OF DASH)
STEERING PAD SWITCH
TAIL CANCEL
TEL IND
TR A/D
VIO WIRE
VOICE IND
VOL IND MODE IND SEEK IND
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Instrument illumination circuit (2 of 2) -> (EXCEPT CANH OPTITRON METER) ILLUMINATION IND CANL
